Ceiling Lift Track Components

 

 patient ceiling lifts componentsX-Y Gantry Traversing Trolley Set

The X-Y Gantry Traversing Trolley Set is used to connect the traversing boom to the parallel support rails for an X-Y gantry system. It has charger connections to engage with the end stop charger.


 patient ceiling lifts componentsX-Y Gantry Traversing Trolley Set

The X-Y Gantry Traversing Trolley Set is used to connect the traversing boom to the parallel support rails for an X-Y gantry system. When used with the P-400 and P-600, it does not include any charging connection hardware.


 patient ceiling lifts componentsX-Y Gantry Manual Traverse Above Mount Trolley Set

X-Y Gantry Manual Traverse Above Mount Trolley Set is used where additional lifting height is required. The traversing rail travels at the same height as the support rails.


 patient ceiling lifts components

X-Y Gantry Power Traversing Trolley Set

The X-Y Gantry Power Traversing Trolley Set allows for full power operation of the X-Y gantry boom. The boom travel is activated via buttons on the hand control.


 patient ceiling lifts componentsCharger End Stop

A Charger End Stop is used with lifts permanently installed in the track (C Series and TA Plus). It acts as both an end-stop and the charger docking station.

 


 patient ceiling lifts componentsEnd Stops and End Stop Safety Pins

The Mid-Track Charger allows the lift to be charged at any location along the track.

 


 patient ceiling lifts componentsEnd Stops and End Stop Safety Pins

The End Stops hold the lift or X-Y Gantry trolley set inside the track and are located at each end of the track. The End Stop Safety Pin is an additional safety measure.


 patient ceiling lifts componentsAuto-Gate

The Auto-Gate enables a transfer between an X-Y Gantry and a single track. The Auto-Gate’s revolutionary design does not require the use of any electrical components. Simply driving the lift into the gate locks it in place to transfer to the other rail.