Ceiling Lift Track Components
X-Y Gantry Traversing Trolley Set
The X-Y Gantry Traversing Trolley Set is used to connect the traversing boom to the parallel support rails for an X-Y gantry system. It has charger connections to engage with the end stop charger.
When used with the P-400 and P-600, it does not include any charging connection hardware.
X-Y Gantry Manual Traverse Above Mount Trolley Set
X-Y Gantry Manual Traverse Above Mount Trolley Set is used where additional lifting height is required. The traversing rail travels at the same height as the support rails.
X-Y Gantry Power Traversing Trolley Set
The X-Y Gantry Power Traversing Trolley Set allows for full power operation of the X-Y gantry boom. The boom travel is activated via buttons on the hand control.
Charger End Stop
A Charger End Stop is used with lifts permanently installed in the track (C Series and TA Plus). It acts as both an end-stop and the charger docking station.
The Mid-Track Charger allows the lift to be charged at any location along the track.
End Stops and End Stop Safety Pins
The End Stops hold the lift or X-Y Gantry trolley set inside the track and are located at each end of the track. The End Stop Safety Pin is an additional safety measure.
The Auto-Gate enables a transfer between an X-Y Gantry and a single track. The Auto-Gate’s revolutionary design does not require the use of any electrical components. Simply driving the lift into the gate locks it in place to transfer to the other rail.